Performing Site Survey - bigj19995/ReyReyRepo GitHub Wiki

Active Scan

Active Scans should be used for post AP deployment or when concerns are about one SSID

Make sure Site Prep work is done
From the home screen of the tool select the AirMapper App
Open AirMaper Settings
Select Floor Plan
Select the Floor Plan for the site you are at from the options listed
Back out of floor plan to AirMapper Settings
Select Survey Mode
Set the mode to Connected (Active)
This requires an active connection to the local WI-FI
Select OK
Select Name
Name the scan with the location you are scanning
Set up the Auto-Test app with the SSID and Password you are looking to scan
Start the Auto-Test scan

Go to the AirMapper home screen
Select START at the top right
Tap on your location within the site map
A red circle will appear, wait for it to turn green
Move to the edge of the now green circle and tap again at your new location
Repeat steps 4 and 5 till the map is completely green
Dots can be removed by selecting the arrow at the top right
The map can be rotated with the button on the bottom right
Select the STOP
If this is done in ERROR you can select RESUME

Passive Scans should be used in pre-deployment or sites where we want total environment data.

Go to the AirMapper home screen
Select START at the top right
Tap on your location within the site map
A red circle will appear, wait for it to turn green
Move to the edge of the now green circle and tap again at your new location
Repeat steps 4 and 5 till the map is completely green
Dots can be removed by selecting the arrow at the top right
The map can be rotated with the button on the bottom right
Select the STOP
If this is done in ERROR you can select RESUME