Assembly - bdring/6-Pack_CNC_Controller GitHub Wiki

Tindie Kit Assembly

The Tindie Kit is nearly fully assembled. There are just a few things to solder and screw together. If you bought a pre-programmed module, much of this will already be done for you because extra testing is done.

Attach the mate to the power terminal block.

They will come pre-installed but can be changed to a vertical orientation.

Install Jumpers

See this page for jumper information

Install Module Supports

Attach the 3D printed module supports using 4 M3x8 self threading screws from the bottom of the board per the picture.

Install Modules

Carefully insert the modules. Make sure the pins are aligned and not offset by one or more pins. Use a M3x8 self threading screw to attach to the support.

Install ESP32 Module

Install the ESP32 module. The USB end goes on the board edge side. There are extra connectors to deal with different width modules.