5030 Bridge Boards Commands - atmel-maxtouch/mxt-app GitHub Wiki

USBtoI2C 5030 Bridge Board Commands

The USBtoI2C 5030 Bridge Board is supported using a propriety interface. This interface uses the USB5030 protocol built into the firmware of the bridge board. These commands are only available when using the USBtoI2C 5030 Bridge board or those development boards with the AT90SUSB1286 chip on them.

The following command options are available to allow custom configuration of the board.

--bridge-config 0xnn : 0xnn, slave address of maXTouch chip, save address saved into EEPROM of bridge

--switch-fast : Switches the bridge board to QRG I/F mode, no USB-HID reports, only USB5030 protocol

--switch-parallel : Switches to HID Parallel Digitizer mode. Takes I2C touch coordinates and converts to USB-HID packets