module power12 and 5 - andreika-git/hellen-one GitHub Wiki

In_vign optional input, 12v when ignition is in start or run.

V12_Raw optional input is power from the main relay.

V12_perm input is battery, hot at all times (very optional - only used for real time clock if not equipped by 3v battery)

5VP denotes a protected 5V output for powering sensors.

EN_5VP input is used to enable the 5VP voltage ("low" - off, "high" - on). To control this input, you can use the PWR_EN output from MM, or use a pull-up.

PG_5VP output can be used for diagnostics; "low" level indicates a short circuit in 5VP power bus. PG_5VP output can be left unconnected if diagnostics are not required.

TLS115D0EJXUMA1 is the best part number

(TLS115B0EJXUMA1 does not have status pin)

See also original power12