How to use - aalesv/2boost GitHub Wiki

If your car does not have Si-Drive switch

  • Start the engine
  • Ensure that Check Engine light is off
  • Press Cruise button
  • When Cruise indicator lights up, settings are switched to alternate set

You can switch table sets at any time by pressing Cruise button. When Cruise light is off main table set is used. When Cuise light is on alternate table set used.

When Check Engine light comes up cruise is disabled and only main table set is used. You cannot switch to alternate table set with Check Engine and blinking Cruise indicator.

If your car has Si-Drive switch

  • Start the engine
  • Ensure that Check Engine light is off
  • Select Si-Drive mode
  • When Si-Drive mode indicator lights up, settings are switched to alternate set

You can switch table sets at any time by selecting different Si-Drive mode. Each Si-Drive mode has its own table set.

You cannot switch to another table set with Check Engine and blinking Cruise indicator.

Overtake button, 2Boost version 3.x

  • Overtake button is available in ver 3 and later. By default it is Cruise Cancel button.
  • Select map as stated above
  • Press and hold Overtake button.
  • Press the accelerator pedal by more than configured level. By default it is 25%.
  • While Overtake button is pressed and accelerator pedal is over the minimum level, Overtake maps set is activated.
  • To return to prevoius mode, release Overtake button.

Overtake button, 2Boost version 4.x

  • Overtake button is available in ver 3 and later. By default it is Cruise Cancel button.
  • Select map as stated above
  • Press and hold Overtake button.
  • Press the accelerator pedal by more than configured level. By default it is 25%.
  • In Press-and-Hold mode while Overtake button is pressed and accelerator pedal is over the minimum level, Overtake maps set is activated.
  • In Press-and-Release mode when Overtake button is pressed and accelerator pedal is over the minimum level, Overtake maps set is activated and remains active even if Overtake button and accelerator pedal are released.
  • CEL is rapidly flashing while Overtake mode is active.
  • To return to prevoius mode, release Overtake button or accelerator pedal (Press-and-Hold mode) or press brake pedal (Press-and-Release mode).