Mainpage

Mainpage top

hotend and bed temperature

• set hotend and bed temperature (always available)

"feedrate" aka printspeed

• set the print speed linear in percent (editable during print over the adjust menu)

z-offset

• set the z-offset aka babystepping (editable during print over the adjust menu)

Mainpage left

Preheat CUST

• CUST Preaheat temperature for bed and hotend with one click. You can preset this under Settings->Device->CUST settings (not available during printing)

Preheat OFF

• set bed and hotend to 0. (not available during printing)

Sound toggle

• turn off/on the sound beep. (always available)

M84

• disable the motors. X Y Z E as only this is possible with the TMC2208_STANDALONE drivers (not available during printing)

Home (G28)

• home printer (not available during printing)

M73

• enable/disable sliced M73 time. If enabled the sliced time will be shown, if disabled the printer time will be used. (only available during printing)

M600

• initiate a immediate filament runout event. advantage of this it reacts immediately and you can do a filament change for example on a infill area (only available during printing)

Mainpage right

mesh status

• mesh size and mesh status. "Valid" or "off".

power loss recovery toggle

• enable or disable power loss recovery. (always available)

filament runout sensor toggle

• enable or disable filament runout sensor. (always available)

Mainpage "printdata"

clock

• time resumed since printstart. (only available during printing)

hourglass

• estimated remaining time. (only available during printing)

filament 0/0 m 0/0 g

• 0/0 m -> sliced filament amount needed in m (meters). the left is the "filament needed to resume the print" in m. the right is in total needed. (only available during printing)
• 0/0 g -> sliced filament amount needed in g (grams). the left is the "filament needed to resume the print" in g. the right is in total needed. (only available during printing)

layers

• layers done and layers total (only available during printing)

Z with two up arrows

• actual z-height. (only available during printing)

two bars with up/down arrow

• sliced layer height. (only available during printing)