Teensy Shields

• PJRC shields:

• • PJRC: Teensy prop shield with motion sensor
• • PJRC: Teensy low cost prop shield, no motion sensor
• • PJRC: Teensy audio adapter
• • • Revision C board is for Teensy 3.1, 3.2, 3.5, or 3.6;
• • • Revision D board is for Teensy 4.0 or 4.1.

• Adafruit Shields

• • Adafruit: Teensy -> Feather Adapter (includes LIPO charger)

• Sparkfun Shields

• • Sparkfun: Teensy -> Arduino shield
• • Sparkfun: TeensyView, 128x32 mono OLED diplay
• • Sparkfun: Teensy 3.2, 4.0, and LC Qwiic shield
• • Sparkfun: Teensy 3.5, 3.6, and 4.1 Qwiic shield

• Onehorse Shields:

• • Onehorse: STBC08 High-Current LiPo Battery Charger
• • Onehorse: LiPo battery charger add-on

• Burgess World Shields:

• • Burgess World: Arduino shield for Teensy 4.0, ESP8266 wifi, bluetooth
• • Burgess World: Arduino shield for Teensy 3.2, ESP8266 wifi, bluetooth

• Raster Shields:

• • Raster: Break out Teensy 3.2/4.0 v1.4 to use screw terminals, 13 ground pins in back row, no 3.3v pins
• • Raster: Break out Teensy 3.2/4.0 v1.6 to use screw terminals, 7 ground pins in back row, 6 3.3v pins

• Blackaddr Shields:

• • Blackaddr: Arduino Teensy Guitar Audio Shield
• • Blackaddr: Adapt Teensy 4.0 to Teensy Guitar Audio Shield

• Other Shields:

• • HighCee Aerial Robotics: JST GH-1.25-4P connectors for I2C0, I2C1, CAN0, CAN1, SER2 and SER5
• • Knick Knack Sound: Phin6 MIDI Controller (powered by Teensy)
• • Pico: Teensy 3/LC Proto board, Arduino Shield, nRF24L01+
• • Hyperbolic Labs: Nano-sized LiPo Charger for Teensy (Out of stock since October 2019)
• • Tobbera: Teensy 3.2 CAN bus module
• • Robot Tech: Teensy 3.5 Motor Control
• • Blino: TeeNaps :: EEG Hat (For Teensy 3.2)
• • Fusion: Dual CAN-Bus adapter for Teensy 3.5, 3.6
• • 8bitforce: Teensy Adapter for RetroShield
• • Fire Brand Forge: Lightsaber Prop Shield for Teensy 3.2
• • Fredick Hübinette's Teensy Saber Electronics V3
• • Teensy Beats Shield Bare PCB