Prototype Boards - TeensyUser/doc GitHub Wiki
Here are some of the prototype boards for mounting your project via soldering:
- DrAzzy: Various sizes of prototype boards
- DrAzzy: 2" x 4" prototyping boards
- DrAzzy: 1" x 2" prototyping boards (perfect for Teensy 3.2/4.0)
- DrAzzy: mint-tin prototyping board
- DrAzzy: Prototype boards with breakaway mounting holes
- DrAzzy: 4" x 4" premium prototyping board
- Adafruit mint-tin perma-proto board, 30x2 rows of pins, outside power rails
- Adafruit plain mint-tin container
- Adafruit 1/2 sized perma-proto board, 30x2 rows of pins, outside power rails
- Adafruit 1/4 sized perma-proto board, 15x2 rows of pins, outside power rails
- Adafruit full sized perma-proto board, 60x2 rows of pins, outside power rails
- Adafruit small mint-tin perma-proto board, inside power rails (just right for Teensy 3.2/4.0)
- Adafruit combination perma-proto pack
- ElectroCookie combination prototype boards
- ElectroCookie double column prototype board
- ElectroCookie large prototype board
- ElectroCookie snapable prototype board
- ElectroCookie Mini PCB prototype boards
- Treedix, 63x2 rows of pins, outside power rails
- Treedix, 63x2 rows of pins, no power rails
- Treedix, 30x2 rows of pins, outside power rails
- Treedix, 17x2 rows of pins, no power rails
- Treedix, 63x4 rows of pins, outside power rails
- Robot50.net board -- this board is no longer sold, but the board creator has put up the designs on the internet so you can print them up at a PCB fabricator like http://oshpark.com. It is useful for Teensy 3.2 and 4.0 because it brings out a parallel set of pins to bring out your devices. However, with only 20 pins being brought out, it is not as useful for the Teensy 3.5, 3.6, or 4.1.