Free Version - ShikOfTheRa/scarab-osd GitHub Wiki

!! DUE TO ITS AGE, SERIOUSLY CONSIDER UPGRADING TO LATEST VERSION !!

This early version of the MWOSD GUI and firmware is free and available to all at no charge.
Please consider the very small cost to run the latest version. It contains many bugfixes and enhancements.
The small cost of the GUI helps fund continued and future development
GPSOSD and Ardupilot / PX4 users should consider only running 1.8 and greater.
DUE TO ITS AGE, SERIOUSLY CONSIDER UPGRADING TO LATEST VERSION

Download MW OSD 1.6 source code software zip.
Download Arduino (1.6.5 is build version)
Connect OSD via USB and install any drivers necessary
Open Arduino IDE and configure Arduino Board/Processor/Com port
From within Arduino IDE, and browse to / load MWOSD.INO from MW_OSD folder
Select config.h tab from within Arduino
define OSD Hardware by removing "//" from beginning of line for your HARDWARE
define Flight Controller by removing "//" from beginning of line for your CONTROLLER
define Aircraft Type by removing "//" from beginning of line for your AIRCRAFT TYPE
Click Sketch and Upload from Arduino menu

The free version is available in the MWOSD 1.6 download pack.

Click on the three lines shown on the top-right corner in your browser, which will open a menu for you.
Click on “Settings.” You will be redirected to your browser’s settings page.
Once on the Settings page, click on the “Extensions” link given in the left-hand side of your screen.
It will take you to the extensions page that shows all the extensions you have installed in your browser.
On the extensions page, you should see a checkbox on the top saying “Developer mode.” Click on it.
Drag the MWOSD GUI R1.6.CRX file and drop it onto the extensions page.
Once you have dropped the file, you may be prompted to add the extension to your browser.
Click on “Add” / "Continue" to manually install the extension.
Follow the prompts to install it