BC8011 - ShadowJonathan/ByteCart GitHub Wiki

The BC8011 sign is used in a new version of router appeared in version 3.1.0.

It has a different layout than a BC8010 router, more compact, and all redstone stuff is hidden.

To transform a BC8010 router in a BC8011 router, the specific BC8011 construction part below is mandatory to replace the core of the router. BC8010 signs must be replaced by BC8011 signs.

The non-specific part is optional, it will hide more redstone dust.

The sign itself must contain on its 4th line the address of the track on which it depends. this address can be filled automatically by bcupdater command, so users can leave it blank.

Construction

Note: the specific part for BC8011 starts here

Dig a 3x3 hole deep of 2 blocks. Add 4 holes.

Put 4 repeaters in the holes. North is up (orientation or repeaters is important !).

At level -2, put a chest at the center.

At level -2, put 4 redstone dust and 4 torches as on the picture. Fill the void with blocks of your choice.

Note: the specific part for BC8011 stops here. All following operations are now also valid for BC8010

Attach a lever to the block where torches are attached, on the opposite face. Make sure the lever is off.

Repeat for each direction.

In East direction, put 2 levers and 2 redstone torches as in the picture. Put a sign with BC8011 written on the second line. Make sure the levers are off.

Repeat this in South direction.

In West direction, put 2 levers under the blocks as in the picture. Put a sign with BC8011 written on the second line. Make sure the levers are off.

Repeat this in North direction.

Now fill the void with the material of your choice. Here is where the tracks bill be put:

Put the tracks. Make sure the curves are as in the picture (all levers off, North is up):