CSL (aplic WDP 303075) - RTurala/Sonoff-Tasmota GitHub Wiki
Connection
Vcc - 3,3V
TX - RX
RX - TX
GND - GND
For flashing you need to connect GPIO0 to GND
Additional Information
Hardware details
- ESP8266 - on TYWE2S Module
- HLW8012 - Power Monitor Chip
- SRU 5VDC SDA - Relais
GPIO0
You need to solder a wire to the test-point on the TYWE2S Module to be able to enter the flashmode. The Resest Pin has no function for that purpose.
Device Images
GPIO Config
Power Monitoring will not work with that configuration... wait for software update in case you want to use it