BlitzWolf SHP6 - RTurala/Sonoff-Tasmota GitHub Wiki

BlitzWolf SHP6

Serial Connection

Please see the Hardware Preparation page for general instructions.

Step 1

Disconnect device from power source!

Step 2

Remove one screw on the back of the device. PH1 screwdriver required.

One PH1 Screw

Step 3

Undo 2 screws. PH1 screwdriver required. Disconnect antenna.

Two PH1 Screws and antenna

Step 4

Carefully remove PCB from casing for easier soldering.

  • Don't stress antenna cable too much.
  • Don't lose metal tube.

Step 5

Solder cables to the ESP Pins.

Solder points

Step 6

Connect serial adapter and make a shortwire between Pin IO0 and GND during startup (for entering flashmode). Soldered cables

Step 7

Flash Tasmota.

Other photos

Left side Right side Back All parts

Home Assistant configuration

configuration.yaml

switch:
  - platform: mqtt
    name: "Blitzwolf"
    state_topic: "stat/blitzwolf/POWER"
    command_topic: "cmnd/blitzwolf/POWER"
    payload_on: "ON"
    payload_off: "OFF"
    retain: false
  
sensor:
  - platform: mqtt
    name: "Blitzwolf Energy Today"
    state_topic: "tele/blitzwolf/SENSOR"
    value_template: '{{ value_json["ENERGY"]["Today"] }}'
    unit_of_measurement: "kWh"
  - platform: mqtt
    name: "Blitzwolf Energy Yesterday"
    state_topic: "tele/blitzwolf/SENSOR"
    value_template: '{{ value_json["ENERGY"]["Yesterday"] }}'
    unit_of_measurement: "kWh"
  - platform: mqtt
    name: "Blitzwolf Energy Total"
    state_topic: "tele/blitzwolf/SENSOR"
    value_template: '{{ value_json["ENERGY"]["Total"] }}'
    unit_of_measurement: "kWh"
  - platform: mqtt
    name: "Blitzwolf Power"
    state_topic: "tele/blitzwolf/SENSOR"
    value_template: '{{ value_json["ENERGY"]["Power"] }}'
    unit_of_measurement: "W"
  - platform: mqtt
    name: "Blitzwolf Voltage"
    state_topic: "tele/blitzwolf/SENSOR"
    value_template: '{{ value_json["ENERGY"]["Voltage"] }}'
    unit_of_measurement: "V"
  - platform: mqtt
    name: "Blitzwolf Power Factor"
    state_topic: "tele/blitzwolf/SENSOR"
    value_template: '{{ value_json["ENERGY"]["Factor"] }}'