6.Virtual Implementation - R-Division-2022-2023-Odd/Repo-09 GitHub Wiki
6.1. 3D MODELING
Subsystem 1
Subsystem 2
Subsystem 3
6.2. CIRCUIT DIAGRAM
6.3. FLOW CHART
6.4. BILL OF MATERIALS
| SI NO. | Part Name | Material with which the part is made of | Description about the part | Quantity Required | Fabrication process if needed |
|---|---|---|---|---|---|
| 1 | Base | Foam board | 3 feet^2 | 1 | - |
| 2 | Micro controller | Arduino mega 2560 | AT2560 | 1 | - |
| 3 | DC Motor | - | 60rpm | 1 | - |
| 4 | Adapter | - | 12v,2A | 1 | - |
| 5 | LCD Display Screen | - | 16*2 | 1 | - |
| 6 | Resistor | - | 10k ohm | 1 | - |
| 7 | Resistor | - | 100 ohm | 1 | - |
| 8 | Resistor | - | 1k ohm | 1 | - |
| 9 | Breadboard | - | - | 1 | - |
| 10 | Jumper wire | - | Male-Male | 1 | - |
| 11 | Jumper wire | - | Male-Female | 1 | - |
| 12 | USB Cable | - | A to B | 1 | - |
| 13 | Acrylic sheets | - | 12cm | 2 | cutting |
| 14 | screws | - | 4 to 8cm | 10 | - |
| 15 | Belt | Bandage | 24cm | 1 | - |
| 16 | Buzzer | - | 5cm | 1 | - |
| 17 | Input recive buttons | switch button | 3*2cm | 4 | - |
| 18 | LED bulbs | - | - | 2 | - |
| 19 | Nylon rods | - | 13.5mm | 2 | - |
6.5. MECHANISM AND RESOURCE SPECIFICATION
Mechanism used is Conveyor belt mechanism
Motors used in our project are:
| MOTORS USED | QUANTITY | LOAD CURRENT |
|---|---|---|
| DC Motor | 1 | 1000milliamps |
Total Load Current=1000milliamp
1000x1.2=1200
So we use the adapter of 2amp adapter at 12v voltage
6.6. 3D MODEL
SIDE VIEW OF THE 3D MODEL
TOP VIEW OF THE 3D MODEL
