NEW: TMM RUNS - PADME-Experiment/padme-fw GitHub Wiki

First log in

  • ssh daq@l0padme6
  • pwd: work-1

Open the server:

  • cd ~/chamber/MMDAQ3-Source-ROOT6/mmdaq3-server
  • ./mmdaq3-server

Open the Browser:

  • cd ~/chamber/MMDAQ3-Source-ROOT6/eventbrowser
  • ./browser --online

Physics Run

  • Click on Physics

  • Check Write File

  • Click on Daq Config File

  • Navigate into:
    ~/chamber/MMDAQ3-Source-ROOT6/Configuration/config_1FEC_FINAL

  • Select: DAQ_config.xml

  • Click on Open

  • Wait until the bar becomes green

  • Click on Pedestal File (below the Daq Config File button)

  • Navigate into: ~/chamber/data_TMM/pedestal/

  • Select the file that corresponds to the Pedestal run (if you didn't do a new pedestal run, check on elog to see what pedestal run was used previously)

  • Wait until the bar becomes green

  • Set the Zero Suppression Factor to 0.5 and press Enter once the value is set to send the command NB: you can check if the command is been taken if in the browser terminal there's a line saying: CDaqClientIpc::send_commands() --> sent:'zsapv=0.5'

  • Click on Start (if all is went at the best the button should be turn green)

  • Go to the server terminal and check that after the ======== STARTING PHYSICS RUN ======== it waits the trigger from PADME showing - 0, 0 or \ 0, 0 or / 0, 0 (with the slash moving)

    NB: during the configuration for the starting of the run there should pop out some warnings (in orange), don't worry about that

  • Once the run is started, and the trigger is going, click on “TestBeam_setup_down” and then on Readout/Event1D to check that there is something in all the plots

  • Go to the server terminal and check that there are no error messages that appear during the run

To stop the run:

  • Click on Stop
  • Click on Kill Server
  • Close the browser

Author: Paolo Massarotti, Giada Mancini - for any question contact them at [email protected], [email protected]