wire display - OpenSourceEBike/TSDZ2_wiki GitHub Wiki
Important: You must disconnect both the battery and the motor when modifying the wiring loom. The motor contains capacitors which are likely to irreversibly damage the display if the motor is left connected and the loom is wired incorrectly. Once you have modified the loom you must carefully recheck your work before reconnecting the display, motor and battery.
To avoid cutting your original display cable, you would need to find the source of Higo Mini-A dimension connector
TSZD2 motors models are sold with or without a throttle connection. The cable that goes from the motor controller to display is different and here are the details -- you need to identify your cable signals (use a multimeter to measure between GND and P+ battery voltage):
| wire color | function | description |
|---|---|---|
| green | P+ | battery voltage |
| black | GND | ground |
| white | Vin | ground when LCD disabled and P+ (battery voltage) when LCD is enabled |
| brown | UART TX motor controller | sends digital data to LCD |
| orange | UART RX motor controller | receives digital data to LCD |
| purple | brake |
this signal is active low, meaning that when brakes are not active, this wire has 5V and with brakes active this wire has 0 volts. Leave this wire unconnected if you will not be using brake sensors. |
8 pin controller (usually this is a TSDZ2 with throttle):
| wire color | function | description |
|---|---|---|
| blue | P+ | battery voltage |
| black | GND | ground |
| red | Vin | ground when LCD disabled and P+ (battery voltage) when LCD is enabled |
| brown | UART TX motor controller | sends digital data to LCD |
| yellow | UART RX motor controller | receives digital data to LCD |
| green | brake |
this signal is active low, meaning that when brakes are not active, this wire has 5V and with brakes active this wire has 0 volts. Wired with the 5V wire and black GND wire for 3 pin throttle. Leave this wire unconnected if you will not be using brake sensors. |
| white | 5V | |
| orange | throttle | wired with the 5V wire and black ground wire for 3 pin throttle |
| 6 wire color (no throttle) | 8 wire color (throttle) | TSDZ2 controller wire function |
|---|---|---|
| green | blue | (P+) battery voltage |
| white | red | Vin |
| black | black | GND ground |
| brown | brown | UART TX motor controller |
| orange | yellow | UART RX motor controller |
| purple | green | Use with brakes |
| na | orange | Use with throttle |
| na | white | For hidden brakes and throttle |
You can wire the brakes to brake wire and you will also need to wire the GND wire. If you are using a “hidden wire brake sensor”, you will also need to connect the 5V wire.
For the throttle, you will need to connect the throttle wire, the GND and 5V wire.
Some example of soldering wires :
(nb. Correct way is to stagger the cuts so that they would not short even without heatshrink, this makes a small neat bundle)
