NP1380 Hardware - OpenNoah/OpenNoah.github.io GitHub Wiki

Overview

Hardware Part number Features
CPU Ingenic JZ4740 PM DS 336MHz JzRISC 32bits (mipsel)
SDRAM HY57V561620FTP-H 64MiB (2x 4Banks x 4M x 16bits)
NAND K9GAG08U0M 2GiB (4096Blocks x 128Pages x (4k+128)Bytes)
LCD PT035TN01-v3 320x240 8-bit RGB mode

Interfaces

Interface Availability Comment
UART UART0 ttyS0 default: 115200bps, 8n1
JTAG Yes
Boot select Yes USB boot working

Keypad layout

PCB connectors

From top to bottom:

Buttons Left Right Buttons
S1: MENU GND GND S4: ESCAPE
S4: UP GND GND S3: PGUP
S2: LEFT NC RT7 S1: PGDOWN
S3: RIGHT LT3 RT6 S2: ENTER
S5: DOWN LT4 RT5
S6: SOUND LT5 RT4
  LT6 RT3
  LT7 NC
  GND GND
  GND GND

Matrix layout

  LT7 LT6 RT7
LT3/RT4 RIGHT UP ENTER
LT4/RT5 LEFT DOWN ESCAPE
LT5/RT6 SOUND MENU PGDOWN
RT3 VOL+ VOL- PGUP

GPIO configuration

Group Config Function
PA0-PA31 AF0 Memory controller: Data bus
PB0-PB16 AF0 Memory controller: Address bus
PB17-PB18 OUTPUT ?
PB19-PB24 AF0 Memory controller: SDRAM specific
PB25-PB26 AF0 Memory controller: Chip select
PB27 INT, HIGH/LOW MMC/SD detection, 1: Present
PB28 INPUT ?
PB29 INT, LOW ?
PB30 INPUT ?
PB31 AF0 Memory controller: Write enable 0
PC0-PC7 AF0 LCD controller: Data bus
PC8 OUTPUT ?
PC9 OUTPUT LCD enable, 1: on
PC10-PC17 [17:10]=II_IIIIOI ?
PC18-PC20 AF0 LCD controller: Clock & sync
PC21-PC22 OUTPUT ?
PC23 INPUT u-boot: LCD Select: IO_C23=1
PC24-PC26 AF0 Memory controller: Write enable 1-3
PC27 OUTPUT MMC/SD power, active low
PC28-PC29 AF0 Memory controller: NAND RD&WR enables
PC30 INPUT Memory controller: NAND ready/busy
PC31 INPUT JTAG(SEL=0)/UART(SEL=1) select
PD0 INPUT Matrix keyboard: RT3
PD1 INPUT Matrix keyboard: LT3/RT4
PD2 INPUT/OUTPUT Matrix keyboard: LT7
PD3 INPUT/OUTPUT Matrix keyboard: LT6
PD4-PD6 INPUT ?
PD7 OUTPUT/INPUT Matrix keyboard: RT7
PD8-PD13 AF0 MMC/SD controller
PD14 INPUT ?
PD15 INPUT Matrix keyboard: LT5/RT6
PD16 INPUT ?
PD17 INPUT Matrix keyboard: LT4/RT5
PD18-PD21 AF0 SSI
PD22-PD24 INPUT ?
PD25-PD26 AF1 UART0
PD27 AF0/OUTPUT PWM4 output, LCD backlight
PD28 OUTPUT ?
PD29 AF1/0 Power button, 0: Pressed
PD30 INPUT ?
PD31 OUTPUT ?