Screw Bolt Listing - Offset-official/Nautilus-One GitHub Wiki

Where	Size	Type	How Many	Notes
Outside Clamps	M3 x 12mm	machine screw	16	Holds clamps together
Outside Clamps to 3DP Structure	M4 x 12mm	machine screw	16	clamps to 3DP
outside end caps to flanged metal end caps	M3 x 16mm	machine screw	24
Thrusters to 3DP structure	M3 x 10mm	machine screw	12
Outside 3DP structure to 3DP structure	1/4-20 x 2in	bolt	8
MDF wood base to 3DP in very back	8-32 x ~1in	machine screw	2	connects MDF to plastic to metal back plate to stop inside from spinning, nut must be on top, very tight fit so bolt needs to be cut likely to correct size
Camera screws	M3 x 10mm	machine screw	4	two front, preferably a few mm shorter than 10 mm
Camera screws	M3 x 8mm	machine screw	2	one back, preferably a few mm shorter than 8 mm. Can use 10mm if small washer is used as spacer
IMU mounts (left tube) to base	M2 x 12mm	self tapping screw	4
OLED mount (right tube) to base	M2 x 12mm	self tapping screw	4
OLED mount to OLED	M2 x 5mm	self tapping screw	4
IMU to IMU mount (if wanted)	M2 x 5mm	self tapping screw	4
Battery Holder 3DP to base	8-32 x .75in	machine screw	16
On/Off Switch 3DP to base	8-32 x .75in	machine screw	2
Jetson/Orbitty 3DP to base	M2 x 12mm	self tapping screw	4	plastic strips out very easily, should be reprinted at some point
Orbitty to Jetson	M3 x 7.5 mm	standoff female-female?	4
Orbitty to 3DP	M3 x short	machine screw	4
Pi to Base	M3 x 7.5mm	standoff female-male	2	machine screw on bottom, MDF base, female-male standoff, Pi, female-female standoff
Pi to Base	M3 x short	machine screw	2
Pi to Base	M3 x 3.7mm	standoff female-female	2
Pi to Pixhawk Mount	M2 x 8mm	self tapping screw	2
PDB to base	M3 x 7.5mm	standoff female-male	8	machine screw on bottom, MDF base, female-male standoff, Pi, female-female standoff
PDB to base	M3 x 3.7mm	standoff female-female	8
PDB to base	M3 x short	machine screw	8