Register Editor - OEFW-community/RT-890-custom-firmware GitHub Wiki

How to use

Register Editor must be enabled with a Makefile flag. It is off by default to save space. So if you want to enable it make sure you have a register-editor enabled firmware build, or build your own.

Start the editor by mapping a key (side key or keypad) to the Reg Editor action using the main menu.
Register Editor will launch, showing the current register values in blue.
The register currently being edited will display in large white font.

Keys

Key	Action
Up	Move editor to next register
Down	Move to previous register
1	Change AGC level
2	Decrease value of current register by 1
3	Increase value of current register by 1
5	Decrease value of current register by 10
6	Increase value of current register by 10
8	Decrease value of current register by 100
9	Increase value of current register by 100
Exit	Exit Register Editor

Note: There is also an key action (mappable to any key) that will cycle through the AGC levels. To use this assign the AGC Mode action to a key. It will cycle between Auto AGC and Fixed AGC levels 1-7. This action is available even if the Register Editor Makefile flag is disabled.