Staggered layers does not take in to account the slope of a wall, leading to Inner-walls getting staggered even when visible from above.
When only_one_wall_first_layer is enabled, the flowrate adjustment to correct for the lifted Inner-walls is not correctly applied
Having multiple models of different heights causes the check for the top layer to only work on the tallest model (even if only 1 of the models has the setting enabled
Orca slicer layer preview sees 1 layer as multiple different layers (usually 3, (lower walls, raised walls, infill). Sometimes 2, (lower walls and infill, raised walls)) (this is worsened if an object has 2 separate sections of outer-walls as they get treated as separate 'towers')
Perimeters on internal holes are not staggered, only the outermost walls
Overhang detection can disable brick/staggered layering, reverting to traditional layers without recovery, leaving gaps/voids and weak points (see Issue #147: Overhangs disable brick layers?)
Incompatible Settings
Adaptive Layer Height is not currently supported
Initial_layer_print_height & Layer_height must currently be the same