MIDAS mixer setup in Oslo - MCT-master/portal GitHub Wiki

Left side – INPUT (audio FROM Connections)

Here is where the the mixer receives audio. Input sections are the 4 buttons on the left of the faders

INPUTS 1-16

for local input (Audio from Microphones). Currently there are 4 microphones set up (Ch 1-4) Adjust these channels to change the level of the incoming signal from the microphones

INPUTS 17-32

Additional external inputs - (small jack for laptop/devices Ch 17-18)

AUX in USB for external (Trondheim) input. This is the signal received from Trondheim, if you would like to change the volume of one of the connections being received over the portal, adjust these faders

aux 1+2 – Zoom

aux 3+4 – Tico

aux 5+6 - Lola

Adjust these AUX to change the level of the incoming signal from Zoom/Tico/Lola

FADER FLIP – sends on fader (sending to the busses - right side of the mixer)

This button will change the fader on the left to show the signal sent to Trondheim (rather than the input volume) This works with all of the AUX channels on the left side of the mixer

To adjust audio sent to each bus on the left, press the SEL button located on the top of each bus channel. Then the faders on the AUX tracks will change and show the level sent to the Bus selected.

Right Side – OUTPUT

The right side of the Midas mixer are the busses routed to the output that is sent to Trondheim.

BUS 1-8 (Audio TO Trondheim)

These are the busses for Zoom/Tico/Lola sent to Trondheim. Adjust these faders to change the level going through the portal sent to Trondheim.

Bus 1+2 – Zoom

Bus 3+4 – Tico

Bus 5+6 - Lola

BUS 9-16 (Audio to extra speakers located on the left of the room)

Bus 9 – speaker left

Bus 10 – speaker right

Extras

Software available to control the mixer – M32-Q (Android, IOS, Windows, Mac)

MCT NTNU (search on zoom to connect)

The Preset for the MIDAS mixer routing can be found from this link MCT STD