Int flip = 2; int val; void setup() { // put your setup code here, to run once: Serial.begin(96000); pinMode(flip,INPUT); pinMode(7,OUTPUT); pinMode(8,OUTPUT); pinMode(9,OUTPUT); pinMode(10,OUTPUT); val = digitalRead(flip); }

void loop() {

int count=0;
//DC MOTOR OF LOW RPM //this is for pushing of dough digitalWrite(7,HIGH); digitalWrite(8,LOW); delay(1000); digitalWrite(7,LOW); digitalWrite(8,LOW); delay(1000);

while(val==0) { count++; } //DC MOTORS OF SOME HIGH RPM SO THAT IT SHOULD HOLD "GEARS" TOO //this is for shaping dough digitalWrite(9,HIGH); digitalWrite(10,LOW); delay(1000); digitalWrite(9,LOW); digitalWrite(10,LOW); delay(1000); }

Thinkercad simulation

https://www.tinkercad.com/things/aEeXUUMIROt-magnificent-waasa/editel