Binding on FS‐I6 X - Kraft2k/icebox-rover GitHub Wiki
Binding:
Enter binding mode on the receiver:
Press and hold the BND button on the receiver. Connect power to the receiver while continuing to hold the BND button. The LED on the receiver will begin to blink rapidly, indicating that it has entered binding mode. Turn on the transmitter into binding mode:
Make sure all switches on the transmitter are in the down (or off) position and the throttle is at minimum. Press and hold the BIND button on the back of the transmitter (or use the binding menu if available in the firmware). Turn on the transmitter while holding the BIND button. The transmitter screen will display RX binding... or something similar. Successful binding:
Once binding is successful, the LED on the receiver will stop blinking and remain solid. This means that the connection between the transmitter and receiver has been established.