Foxeer Reaper VTX - KissUltra/wiki GitHub Wiki

Foxeer Reaper VTX FAQ

---

Q: I can't get Smart Audio working on the Foxeer Reaper Extreme VTX. How do I need to set it up in the Kiss Ultra GUI?

A: The Foxeer Reaper Extreme works with IRC Tramp protocol. Somehow, Foxeer implemented some odd values to be used. To use the maximum output power of 2500mW, you need to set the value in GUI or OSD at 600. See the yellow outlined parts of the picture below how to setup the VTX configuration in the advanced tab in the Kiss Ultra GUI. Values that can be used for the Extreme VTX: set 25 for 25mW output, 100 for 200mW output, 200 for 500mW output, 400 for 1500mW output and 600 for 2500mW output.

---

Q: I am using a Foxeer Reaper Extreme VTX. I have followed all the suggestions how to connect an analog VTX and camera to the Ultra FCFC, but am not able to get clean FPV video feed. Is there something else I can do to improve it?

A: The connector of the Foxeer Reaper Extreme has 2 ground (GND) wires. They are separate ground wires for video and power circuits. They MUST both be connected to a common ground to get clean video feed.

Thank you EbrFPV for nice page and Gavrfpv for 2 grounds tip!