Setup - HomeKidd/HomeKit-ZemiSmart-LED-Bulb-ESP8266 GitHub Wiki

Wi-Fi Setup

Donate
You must configure wifi network before adding the accessory to HomeKit. To configure Wi-Fi settings, device generates its own Wi-Fi in AP mode. You must connect to it in order to setup your Wi-Fi network.

Simply take your iOS device, go to Setting -> Wi-Fi, and search for an SSID called HomeKid- followed by the module's MAC address and connect to it. For security reasons the AP is password protected!

Default AP password: 12345678


Wait a few seconds until a web appears showing you all Wi-Fi networks that the device has found. Select yours, and enter password then click the Join button! The module will try to connect the selected Wi-Fi network, this will take a couple of seconds.

Note: If the given password is wrong, you can Reset the Wi-fi settings by holding the Reset button for 10sec


HomeKit Setup


In your iOS device, open Home App and follow normal steps to add a new accessory.
Pairing setup takes about 30 seconds.



Default  HomeKit code is 217-84-676.

Also You can scan this HomeKit QR code:




Note: If pairing fails, you can unpower your device, repower it, and start HomeKit setup again (Wifi settings keep configured). After successful pairing the LED Bulb will flashing 3 times!

Reset

Resetting device to factory defaults

The code has a Reset function in case of something goes wrong. Because this bulb doesn't have any button attached to it, i've added a software solution: in any 3rd party Homekit app (e.g.: EVE) theres a custom characteristic for resetting the Bulb to factory default. Simply just turn this Reset switch on, after 5 seconds the device will be resetted.

Note: After switching Reset on the LED Bulb will flashing 5 times

All configured settings has been removed and device is restarting. This removes HomeKit and Wi-Fi settings, and your device will go to Access Point mode next time in order to reconfigure Wi-Fi.

Reconnecting to Wifi network

If wifi network becomes unreachable, device will keep searching Wi-Fi automatically until it can connect again when Wi-Fi becomes available.

Note: Resetting the accessory may not remove it from the Home app, you need to do it manually after resetting! Before resetting the LED Bulb will flashing 5 times, which indicates the start of Reset process!

paypal

⚠️ **GitHub.com Fallback** ⚠️