PS 2 Player Cable Setup Guide - GrechTech/RetroRosetta GitHub Wiki

PS Cable assembly

  1. If recycling a cable from a broken controller, or if using an extension cable, cut the cable 10-40cm from the plug.
  2. Strip 3-5 cm of the outer insulation sleeving from the cable
  3. Cut down the red wire
  4. Strip 5mm from the remaining wires.
  5. Crimp each wire with a female Dupont crimp in line with the Crimping Guide

    PS1/PS2 Dual Port (2 Players or Multitaps) connection diagram

PS1/PS2 Dual Port (2 Players or Multitaps) connection guide

  1. Place a jumper cap on row 18
  2. If not using a quickswap header, then on row 20, place the jumper cap across the two central pins (20B & 20C) of the row
    If you are using a quickswap header, then use a jumper wire to connect pin 20B to pin 3A
  3. Connect the green wire (Port pin 9) of the Player 1 cable to pin 5B
  4. Connect the brown wire (Port pin 1) of the Player 1 cable to pin 6B
  5. Connect the blue wire (Port pin 7) of the Player 1 cable to pin 16B
  6. Connect the orange wire (Port pin 2) of the Player 1 cable to pin 17B
  7. Connect the yellow wire (Port pin 6) of the Player 1 cable to pin 19B
  8. Connect the black wire (Port pin 4) of the Player 1 cable to pin 19A
  9. Connect the grey wire (Port pin 3) of the Player 1 cable to pin 19D
  10. Connect the green wire (Port pin 9) of the Player 2 cable to pin 15B
  11. Connect the brown wire (Port pin 1) of the Player 2 cable to pin 2B
  12. Connect the blue wire (Port pin 7) of the Player 2 cable to pin 13B
  13. Connect the orange wire (Port pin 2) of the Player 2 cable to pin 14B
  14. Connect the yellow wire (Port pin 6) of the Player 2 cable to pin 8B
  15. Connect the black wire (Port pin 4) of the Player 2 cable to pin 2A
  16. Connect the grey wire (Port pin 3) of the Player 2 cable to pin 19C or leave disconnected
  17. Connections should now resemble the diagram