PS 1 Player Cable Setup Guide - GrechTech/RetroRosetta GitHub Wiki

PS Cable assembly

  1. If recycling a cable from a broken controller, or if using an extension cable, cut the cable 10-40cm from the plug.
  2. Strip 3-5 cm of the outer insulation sleeving from the cable
  3. Cut down the red wire
  4. Strip 5mm from the remaining wires.
  5. Crimp each wire with a female Dupont crimp in line with the Crimping Guide

PS1/PS2 Single Port (1 Player or Multitap) connection diagram

PS1/PS2 Single Port (1 Player or Multitap) connection guide

  1. Place the jumper caps on rows 2, 8, 13, 14, 15 and 18
  2. If not using a quickswap header, then on row 20, place the jumper cap across the two central pins (20B & 20C) of the row
    If you are using a quickswap header, then use a jumper wire to connect pin 20B to pin 3A
  3. Connect the green wire (Port pin 9) to pin 5B
  4. Connect the brown wire (Port pin 1) to pin 6B
  5. Connect the blue wire (Port pin 7) to pin 16B
  6. Connect the orange wire (Port pin 2) to pin 17B
  7. Connect the yellow wire (Port pin 6) to pin 19B
  8. Connect the black wire (Port pin 4) to pin 19A
  9. Connect the grey wire (Port pin 3) to pin 19D
  10. Connections should now resemble the diagram