N64 3 Player Cable Setup Guide - GrechTech/RetroRosetta GitHub Wiki

N64 cable assembly

  1. If recycling a cable from a broken controller, or if using an extension cable, cut the cable 10-40cm from the plug.
  2. Strip 3-5 cm of the outer insulation sleeving from the cable
  3. Isolate the inner wires from the cable and strip 5mm from each wire
  4. Crimp each wire with a female Dupont crimp in line with the Crimping Guide

N64 3 Player connection diagram

N64 3 Player connection guide

  1. Place the jumper caps on rows 2, 5, 14, 15, 16, 17, 18, 19 and 20
  2. Connect the red wire of the Player 1 cable to pin 7A
  3. Connect the black wire of the Player 1 cable to pin 6A
  4. Connect the green wire of the Player 1 cable to pin 6B
  5. Connect the red wire of the Player 2 cable to pin 8A
  6. Connect the black wire of the Player 2 cable to pin 9A
  7. Connect the green wire of the Player 2 cable to pin 8B
  8. Connect the red wire of the Player 3 cable to pin 13A
  9. Connect the black wire of the Player 3 cable to pin 10A
  10. Connect the green wire of the Player 3 cable to pin 13B
  11. Connections should now resemble the diagram