N64 1 Player Cable Setup Guide - GrechTech/RetroRosetta GitHub Wiki

N64 cable assembly

1. If recycling a cable from a broken controller, or if using an extension cable, cut the cable 10-40cm from the plug.
2. Strip 3-5 cm of the outer insulation sleeving from the cable
3. Isolate the inner wires from the cable and strip 5mm from each wire
4. Crimp each wire with a female Dupont crimp in line with the Crimping Guide

N64 1 Player connection diagram

N64 1 Player connection guide

1. Place the jumper caps on rows 2, 5, 8, 13, 14, 15, 16, 17, 18, 19 and 20
2. Connect the red wire to pin 7A
3. Connect the black wire to pin 6A
4. Connect the green wire to pin 6B
5. Connections should now resemble the diagram