Example 05c ‐ Motor fix speed, On Off‐Switch (L9110) - GSTCH/SketchMadeEASY GitHub Wiki

Motor fix speed, controlled by switch (L-0-R). Motor turn 100% of the maximum speed forward and into the other direction (backwards) 80%. The motor is controlled by a L9110 chip. If Sketch Made EASY is installed, it can be opened via menu: "File:/Example/SketchMadeEASY/Examples/05-MotorFixSpeedSwitch".

Schematic

Code

The thee variants differ in the definition of the actuator (motor).

#include <Easy.h>

//*****************************************************************
// Parameter Motor L9110
#define MOTOR_PINA1 44
#define MOTOR_PINB1 46
#define MOTOR_PINA2 11
#define MOTOR_PINB2 12
// Parameter of Switch
#define MOTOR_SWITCH_FORWARDPIN 36
#define MOTOR_SWITCH_BACKWARDPIN 37
// Parameter Fix Value
#define MOTOR_SPEED_MIN 0
#define MOTOR_SPEED_MAX 100
#define FIX_VALUE_FORWARDSPEED_SPEED 100
#define FIX_VALUE_BACKWARDSPEED_SPEED -80

void setup()
{
  //((*** Initialize: Configure your sketch here....

  //** Create actuator:
  MotorL9110* motor = new MotorL9110(MOTOR_PINA1, MOTOR_PINB1);

  //** Create input:
  // Switch used by condition in the logic.
  Switch3Position* motorSwitch = new Switch3Position(MOTOR_SWITCH_FORWARDPIN, MOTOR_SWITCH_BACKWARDPIN);

  //** Define logic with conditions and relations
  // Define relation when switch is at position 1 --> Turn forward with fix speed
  CompareCondition* motorForwardCondition = new CompareCondition(motorSwitch, OpEQ, Switch3Position::Pos1);
  Relation1to1* relationMotorForward = new Relation1to1(motorForwardCondition, motor, FixValue::Percent(FIX_VALUE_FORWARDSPEED_SPEED));

  // Define relation when switch is at position 2 --> Turn backward with fix speed
  CompareCondition* motorBackwardCondition = new CompareCondition(motorSwitch, OpEQ, Switch3Position::Pos2);
  Relation1to1* relationMotorBackward = new Relation1to1(motorBackwardCondition, motor, FixValue::Percent(FIX_VALUE_BACKWARDSPEED_SPEED));

  // Define relation when switch is at position 0 --> stopped
  CompareCondition* motorStopCondition = new CompareCondition(motorSwitch, OpEQ, Switch3Position::PosMid);
  Relation1to1* relationMotorStop = new Relation1to1(motorStopCondition, motor, FixValue::Off());
// ***))

  // Initialize control
  ControlManagerFactory::GetControlManager()->Setup();
}

//*****************************************************************
void loop() {
  //*** Run: No additional code is required
  ControlManagerFactory::GetControlManager()->Loop();

  // Depending on Arduino it needs a short delay. Do not add any other delays!
  delay(5);
}
⚠️ **GitHub.com Fallback** ⚠️