SpartaDOS X + Ultimate1MB + FujiNet Utilities - FujiNetWIFI/fujinet-firmware GitHub Wiki

1. Go into Ultimate 1MB BIOS, and set up Ultimate 1MB with the following settings
   • SpartaDOS X Enabled
   • PBI BIOS Enabled
   • SIO Driver: HSIO
   • SIO Devices: D1-D4 or All
2. [B] (Save Changes and Cold boot), wait FOR SDX command processor.
3. Press RESET button on the FujiNet. Wait 5 seconds.
4. Type COLD /N[RETURN] at D1: prompt to force a reboot while disabling cartridge.
5. Wait for CONFIG to boot.
6. Select atari-apps.irata.online from host slots
7. Select Ultimate_1MB_FujiNet_and_UFlash.atr (it's on the second page)
8. Mount it in drive slot 1.
9. Press [OPTION] to mount and boot. The boot will fail (as the disk is not bootable).
10. Return to the Ultimate 1MB BIOS.
11. Press C for cold boot. This will re-enable the SDX cartridge.
12. Once SDX is booted, do a DIR to verify that the disk is mounted. There should be UFLASH.XEX, and three ROM image files.
13. X UFLASH.XEX to start flasher.
14. Select the appropriate ROM size, and load the ROM in the SpartaDOS X slot.
15. Once flashing is complete, ask uflash to reboot.
16. Once back in SDX, verify that FujiNet tools are present and working by typing FCONFIG.
17. Done.

• There are 192K, 256K, and 320K ROMs.
• The 256K and 320K ROMs write over the space used by the Graphical OS slot.
• The 256K and 320K ROMs contain Manpages for the FujiNet tools
• The 192K image contains most of the tools, minus the R* tools and man pages.

Should you wish to use the interactive CONFIG program:

1. Press RESET on FujiNet
2. Wait 5 seconds
3. COLD /N

It was larger than the maximum allowed file size for a single file on the cartridge filesystem.

Too many directory entries in the filesystem.

Use the SDX Imager Tool available here: SDX Imager Tool