SIO Command $F0 Enable UDPStream Mode - FujiNetWIFI/fujinet-firmware GitHub Wiki
This is a command for Device $70 - The FujiNet Device itself (see SIO-Commands-for-Device-ID-$70).
Enable UDPStream Mode ($F0)
Description
Given a hostname or ip address (64 characters) and port as aux1 & 2, it will open a UDP port to the address and allow data streaming. This is used to enable MIDIMaze emulation on port 5004.
Parameters
| DCB | Value |
|---|---|
| DDEVIC | $70 |
| DUNIT | $01 |
| DCOMND | $FB |
| DSTATS | $80 |
| DBUF | Pointer to a 64 byte buffer containing hostname or ip address, example below |
| DTIMLO | $0F |
| DBYT | 64 |
| DAUX1 | byte 1 of port |
| DAUX2 | byte 2 of port |
Examples
C
/**
* Enable UDP Stream on HOST / PORT
*/
void fuji_sio_enable_udpstream()
{
char host[64];
int port = 6502;
strcat(host, "192.168.1.118");
set_sio_defaults();
OS.dcb.dcomnd = 0xF0; // Enable UDP Stream
OS.dcb.dstats = 0x80; // Computer->Peripheral
OS.dcb.dbuf = &host;
OS.dcb.dbyt = sizeof(host);
OS.dcb.daux = port;
siov();
}