How to setup GOOSE Single Board computer (SBC) from GOOSE PC version - Fraunhofer-IIS/ogre GitHub Wiki

List of cables and connectors required

Name	Details	Quantity	Comments
USB3.0 cable	cable type A to A	01	for external connection
USB2.0 cable	cable type A to A	02	one internal and one external use (ext: serial control interface)
USB2.0 cable	FTDI cable TTL-232RG-VSW3V3-WE	01	internel use IMX-serial to CYPRESS controller
USB2.0 cable	FTDI cable TTL-232RG-VSW1V8-WE	01	internel use serial control interface
USB3.0 connector	housing connector	01	internel use
USB2.0 connector	housing connector	02	internel use
Ethernet connector	housing RJ45	01	internel use
Power connector	housing connector	01	internel use
Power switch	housing ON-OFF switch	01	internel use
SD card connector	housing micro SD card connector	01	internel use
RS232 connector	housing female connector	01	internel use
Fan	5V, 0.9W	01	housing
Antenna cable	SMA	01
PPS cable	SMA	01	internel use
SMA connector	SMA	02	internel use

Unplug GOOSE from PC and add SBC to it

• Shut down PC from the terminal using sudo shutdown -h now and switch off power at rear power switch

• Open PC-housing on the left side

• Unplug antenna cable

• Unplug the GOOSE power connector

• Remove PCIe slot bracket screw along with the main slot screw

• Remove the complete GOOSE receiver from the PC motherboard.

• Remove GOOSE PCIe plugin card

• Remove the two plastic screws from the PCIe adapter card (connection PC - GOOSE-receiver) and keep them near by

• Unplug PCIe Riser card from SMARC connector

• After removing the PCIe Riser card the setup looks like:

• Unplug the Frontend as and plug in Single Board Computer (SBC) into SMARC connectorshown below:

• Plug-in the Frontend again.

• Fix the SBC on GOOSE with the two plastic screws. As shown below:

Empty PRoPART housing

• Start with an empty PRoPART housing:

PRoPART housing with connectors and GOOSE PC version receiver

• Add the corresponding connectors and cables

Connect USB2.0 cable to service Frontend GUI vendor requests

• Connect the USB2.0 serial cable, please use the lower port of SBC as pointed in the picture

Connect USB2.0 serial control interface cable

• USB on the go, for kernel booting and accessing the SBC directly.

Connect CAN Bus connector

Connect Fan connector

SD card cable connection

Power supply connector

PPS output and Antenna input connection

USB 3.0 connection

Ethernet connection (Type: RJ45)

USB 2.0 connection

Plug in SD card

Final product