CSL (aplic WDP 303075) - FengtianGu/Sonoff-Tasmota GitHub Wiki

Connection

Vcc - 3,3V
TX - RX
RX - TX
GND - GND

For flashing you need to connect GPIO0 to GND

Additional Information

Hardware details

  • ESP8266 - on TYWE2S Module
  • HLW8012 - Power Monitor Chip
  • SRU 5VDC SDA - Relais

GPIO0

You need to solder a wire to the test-point on the TYWE2S Module to be able to enter the flashmode. The Resest Pin has no function for that purpose.

Device Images

SmartPlug PCB-back ESP-Module

GPIO Config

Power Monitoring will not work with that configuration... wait for software update in case you want to use it

UPDATE: with Tasmota 6.3.0 you have fully monitoring support (Add support for CSL Aplic WDP 303075 Power Socket with Energy Monitoring (#3991, #3996))

generic_config