Cisco Commands - Cyber-JL/NET-330-02 GitHub Wiki

Switch Commands

  (config)interface range FastEthernet 0/x-y (let's you configure multiple ports at one time)

  (config-if-range)switchport access vlan x (defines the vlan for all ports in the range)

  (config)ip routing (turns on routing on multilayer switches)

  (config)interface vlan 100 (brings you into vlan interface config mode)

   (config-if)ip address 10.25.100.1 255.255.255.0 (set the ip address of 10.25.100.1 for vlan 100 on a routing switch) NOTE: This only needs to be set on the router-switch acting as the gateway for the vlan

   enable (this enables the device)

   config (switches from global console to config console)

   no shutdown (used mainly for Vlan1 this command makes sure that the selected vlan is up and will not turn off)