Upgrading Firmware - Cinetronix/ronin-bridge-public GitHub Wiki

Update from the web interface

To update the firmware using the web interface, follow the steps below:

1. Start by downloading the firmware file (rs2_bt_lite-vX.Y.Z.bin) to either your laptop or mobile phone
2. Connect to the WiFi network of the device
3. Open a web browser and navigate to http://192.168.88.1/update.html
4. On the web page, locate the option to upload a file and select the downloaded firmware file (rs2_bt_lite-vX.Y.Z.bin)
5. Ensure that you do not close the page or the web browser during this process
6. Wait patiently for the device to complete the power cycle, which may take some time
7. Finally, verify the updated firmware version by checking the information displayed in the web browser

Rollback to the factory firmware

To perform a rollback to the factory firmware, follow these steps:

1. Begin by disconnecting the power source from the device
2. Proceed to bridge two extreme contacts using either a piece of wire or tweezers
3. Power on the device
4. Wait patiently for approximately 7 seconds until the LEDs start blinking
5. Once the LEDs start blinking, carefully remove the piece of wire or tweezers
6. Allow some time for the WiFi network to become available before proceeding furthe