DRAFT: TO BE FINISHED

If you got a part in your hands, first identify its type

If the part has already been registered, you should find it in the DB. Go to OMS, and enters its barcode in the appropriate selector. If you see the message Looks like there is no data in each portlet, most probably the part has not been registered yet (in fact, it can be registered, but has not yet subject to any activity). To check that, go to the list of parts, then

1. Filter by barcode (click on the filter icon at the bottom left part of the table)
2. Enter the barcode
3. If the table is empty you need to register the part
4. if the barcode is listed in the table you can proceed with the QCQA measurements

If the part is in the DB you can proceed according to its type, as follows:

1. ETROC

2. LYSO Matrix

   • step 1
   • step 2

3. Single bar crystal

   • step 1
   • step 2