SUBSYSTEMS

---

Sl.no.	Names	Subsystems
1	Anurag	Blades
2	Anusha	motor
3	chetan	Disc and box
4	Keerti	Gear

---

3D MODELS

---

BLADES

---

---

ASSEMBLY

MOTOR

---

---

GEAR

---

---

Disc and joints

---

---

Storage box

L Clamp

FLOW CHART

FLOW CHART 1.1

---

---

FLOW CHART 1.2

---

---

FINAL FLOW CHART

---

CIRCUIT DIAGRAM

---

CIRCUIT DIAGRAM 1.1

---

CIRCUIT DIAGRAM 1.2

---

CIRCUIT DAIAGRAM 1.3

---

CIRCUIT DIAGRAM 1.4

---

BILL OF MATERIALS

SL NO	PART NAME	MATERIAL WITH WHICH THE PART IS MADE UP OF	DESCRIPTION ABOUT PART	QUANTITY REQUIRED
01	Front blades	Acrylic sheet	Forms the front rotating pattern	6
02	Rear blades	Acrylic sheet	Forms the rear rotating pattern	6
03	Front wing center	Foam sheet	Serves as a base for joining the ribs that forms the entire front rotating pattern	1
04	Rear wing center	Foam sheet	Serves as a base for joining the ribs that forms the entire front rotating pattern	1
05	DC motor	Iron mixed with carbon for mechanical structures and silicon steel for cores.A magnetic circuit is configured through the air gap between the stator and the rotor cores	Initiates and drives the movement of kinetic sculpture	1
06	Ball bearing	Stainless steel	To carry the loads and reduce friction and position moving machine parts	1
07	Rear stand	Plywood	Supports te entire assembly, acts as a provision for rigidly mounting on the wall	1
08	L Clamp	Stainless steel	Holds the motor to a fixed position	1
09	Bevel gears	Steel	Connecting the wing and motor	2
10	M3 bolt	Stainless steel	Joining V belt and wing	1
11	Box	Foam Sheet	Use to keep Arduino and oher components	3

---

SL NO	PART NAME	MATERIAL WITH WHICH THE PART IS MADE UP OF	DESCRIPTION ABOUT PART	QUANTITY REQUIRED
01	Arduino Uno	Metal-oxide semiconductor integrated circuit chip	It has 14 digital input/output pins, 6 analog inputs,a 16 MHz ceramic resonator , a USB connection , a power jack, an ICSP header and a reset button	1
02	Breadboard	Plastic block	The plastic board used to hold electronic components that are wired together	1
03	Connecting wires	Alloys ,copper ,aliminium etc	Red , black etc	15
04	Resistor	Finely powdered carbon and insulating materials	Two terminal electical device used to reduce current flow and adjust signal levels	8
05	Battery	Made up of steel and mix of zinc manganese, potassium and metal or plastic sheet	Source of electric power	1

---

SL NO	PART NAME	MATERIAL WITH WHICH THE PART IS MADE UP OF	DESCRIPTION ABOUT PART	QUANTITY REQUIRED
01	Push button	Plastic or metal	An elecrical switch operated by pressing a button, closes or opens the circuit with a press	2
02	Potentiometer	Resistive element	Controls the speed of the motor	2