Building the LNA - BenningtonCS/Telescope-2014 GitHub Wiki
- Attached the coupler to the "In" side of Amp 1.
- Then attached the bandpass filter to the "Out" side of Amp 1.
--
- Connected one coaxial cable to bandpass.
--
- Connected opposite end of coaxial cable to "In" side of Amp 2.
--
- Cut two lengths of 15-20 centimeter long 22 gauge copper wire.
--
- Soldered one wire to both Amps.
- Soldered the other wire to Amp 2.
--
- Soldered the other end of the second wire to the 12 volt pin on the bias tee.
- Connected "RF" side of the bias tee and "out" side of Amp 2 with coaxial cable.
--
- Placed this group into the case, with coupler and "RF DC" side of the bias tee protruding from the holes.
--
- Placed on rubber lining, and case cover, wrote LNA on top, and screwed into place.
--