6. VIRTUAL IMPLIMENTATION - B-Division-2022-2023-Odd/Repo-10 GitHub Wiki
6.1 3D MODELLING
3D MODELLING OF THE PROTOTYPE
6.2 CIRCUIT DIAGRAM
- CIRCUIT DIAGRAM OF FLIPPING UNIT
- CIRCUIT DIAGRAM OF SENSING UNIT
- CIRCUIT DIAGRAM OF DIPENSING UNIT
- CIRCUIT DIAGRAM OF THE PRPTOTYPE
6.3 FLOW CHART
- FLOW CHART FOR FLIP MECHANISM
2.FLOW CHART FOR SENSING MECHANISM
3.FLOW CHART FOR DISPENSING MECHANISM
6.4 BILLS OF MATERIAL(BOM)
| SI.NO | Parts Name | Material with which the parts is made up of | Description about part | Quantity required | Fabrication process if needed |
|---|---|---|---|---|---|
| 01 | Flip boards (left & right) | Foam sheet | 42cm15cm4mm | 2 | Cutting |
| 02 | Flip board (On top) | Foam sheet | 21cm12cm4mm | 1 | Cutting |
| 03 | Dispensing Board | Foam sheet | 21cm12cm4mm | 1 | Cutting |
| 04 | Supporting body | Foam Sheet | 42cm4inches8mm | 1 | cutting |
| 04 | Rods | Nylon rods | 6mm*35cm | 3 | Cutting and Bending |
| 05 | Dispensing box | Foam sheet | 20cm8cm8mm | 1 | Cutting |
| 06 | Nuts and Bolts | Iron/Steel | 2mm*15mm | 16 | - |
| 07 | Nuts and Bolts | Iron/Steel | 3mm*10mm | 16 | - |
| 08 | Nuts and Bolts | Iron/Steel | 3mm*20mm | 16 | - |
| 09 | Hinges | Iron/Steel | 1.5 inches | 6 | - |
| 10 | L Clamps | Iron | 1 inches | 14 | - |
| 11 | Jumper Wire | - | m to m | 12 | - |
| 12 | Thread | - | 15 cm | 4 | - |
| 13 | Sensor | - | IR | 1 | - |
| 14 | Servo Motor | - | Tower Pro MG996R | 4 | - |
| 15 | Micro Controller | Audrino Mega | AT2560 | 1 | - |