Note 10 Debug Settings - Atlas-Night-Out/xDrip-plus GitHub Wiki
These are the recommended G6 settings from 12 Oct 2021 release of xDrip or later.
This was a very hard one to figure out why xdrip would not show me my readings and it did not work on my Samsung Note 10+ for over 2 months!
I had to resort
back to my old 80 Transmitter but the newer serials worked fine with a Samsung Note 8
But to get a Dexcom 8S transmitter working I managed to figure out the correct setting to use.
A big thank you goes to Richard Would, on fixes Galaxy S20 5G version of Android 11 debug settings
on a Dexcom SN: 8P
so I tried these settings on a Samsung Note 10+ on a Android 11 with a Dexcom Transmitter SN:8S which fix my two month
transmitter issues and finely worked for me
I hope this fix will help other people with these annoying debug setting issues. I also tried Navid Debug setting!
as well as my own but did not help fix my issues with a Note10+ and had no luck,
but if these setting don't work for you maybe try Navid setting as well. each mobile will have different issues and working ways!
So I will post below my debug setting for you all and also the version of xdrip that you will need to upgrade too for this process to work!
I also had to update to the lastest version but found issues at the time that also did not work so I went down a few versons to see which would get it to work
you might also have to do the same things, but I would update to the latest version first! In my case I used xdrip Version 2021.07.02 if you need to update
then see Here!
xdrip Version Used on a Android 11 Mobile - Download Here!
1
Go to your Debug Settings to make changes:
1 2
3
Make your Changes Here:
4
Hanberger > Settings > G5/G6 Debug Settings > Preemptive Restarts
1 2
3 4
Hanberger > Settings > Less Common Settings > Other misc options
Hanberger > Settings > Less common settings > Other misc options
Enable Samsung workarounds even if your phone is not Samsung
1 2
3
4
Enable Samsung workarounds even if your phone is not Samsung