AlceOSD 0v3 Powering Options

Powering from 12V video connector:

• Short 12V solder jumper
• Short JP1 so that board is powered from LDO
• Voltage on 12V video connector pin should not exceed 16V (3S battery)
• Board will get hot when using this method (LDO will heat) but that should not be a problem
• You can add a small heatsink over the LDO (U10) to help dissipating the heat

Powering from telemetry connector:

• Open 12V solder jumper
• Short JP1 so that board is powered from telemetry connector pin
• Don't exceed 5.5V on the 5V telemetry pin