lcd_io_10_port_configuration - Anobium/Great-Cow-BASIC-Help GitHub Wiki

LCD_IO 10 Port Configuration

Using mode 10

When using I2C LCD mode 10 the target I2C device address is setup as shown below. Each bit of the the variable i2c_lcd_byte is defined to address the correct LCD display port.

    i2c_lcd_e = i2c_lcd_byte.2
    i2c_lcd_rw = i2c_lcd_byte.1
    i2c_lcd_rs = i2c_lcd_byte.0
    i2c_lcd_bl = i2c_lcd_byte.3
    i2c_lcd_d4 = i2c_lcd_byte.4
    i2c_lcd_d5 = i2c_lcd_byte.5
    i2c_lcd_d6 = i2c_lcd_byte.6
    i2c_lcd_d7 = i2c_lcd_byte.7

If you have an I2C LCD display adapter with a different set of connection of the adapter then change this configuration to suit the specific of the adapter as follows. This should be done in the your main program code.

    #define i2c_lcd_e i2c_lcd_byte.1
    #define i2c_lcd_rw i2c_lcd_byte.2
    #define i2c_lcd_rs i2c_lcd_byte.0
    #define i2c_lcd_bl i2c_lcd_byte.3
    #define i2c_lcd_d4 i2c_lcd_byte.7
    #define i2c_lcd_d5 i2c_lcd_byte.6
    #define i2c_lcd_d6 i2c_lcd_byte.5
    #define i2c_lcd_d7 i2c_lcd_byte.4
⚠️ **GitHub.com Fallback** ⚠️