Clockworks 3D Print Shop - Angel-125/Pathfinder GitHub Wiki
Mass: 5t
Cost: 2,100 Equipment
Research: Science Tech
The larger cousin to the Blacksmith, the Clockworks is one of the configurations for the Hacienda Inflatable Factory. It is only available if you have the OSE Workshop mod installed. With OSE Workshop, you'll be able to 3D print the parts that you find in the VAB and SPH using MaterialKits. Some parts will require ExoticMinerals and RareMetals as well. You can print parts with a volume up to a maximum of 14,500 liters. But unlike the Blacksmith, the Clockworks can produce MaterialKits, and can sift through dirt to find rare metals and exotic minerals.
Below is the ops window for the Clockworks:
As with all converters controlled through the ops view, simply click on the check mark next to the converter to enable it. Each converter shows its current efficiency rating as a percentage enclosed by parenthesis.
The Clockworks has the following converters:
Make MaterialKits
This converter produces MaterialKits from Ore. It has the following recipe:
Inputs
Ore: 1 units/sec
ElectricCharge: 5 units/sec
Output
MaterialKits: 0.375 units/sec
Prospecting
This converter produces sifts through Dirt to find valuable resources. It has the following recipe:
Inputs
Dirt: 1 units/sec
ElectricCharge: 5 units/sec
Output
RareMetals: 0.02 units/sec
ExoticMinerals: 0.02 units/sec
Managing The Workshop
The Clockworks has the same controls as the Blacksmith:
Resource Mode (1): This field displays which resource you are currently using to produce parts with. It will either be MaterialKits or RocketParts.
Workshop and Recycler Status (2): These fields show you what's currently going on with the Workshop and Recycler, respectively.
Open Workshop (3): Click this button to open the OSE Workshop window.
Open Recycler (4): Click this button to open the OSE Recycler window.