Foxeer F7 - rotorflight/rotorflight GitHub Wiki
Rotorflight Wiki is replaced by www.rotorflight.org.
The Foxeer F722 V2 is an F722 based FC that runs on 2S to 6S. It is a 20x20mm mounting pattern.
The FoxeerF722V2 uses the FoxeerF722V2 Target. Flash Rotorflight using this target and select 'Load Custom Defaults' before applying the remapping files shown below. There are two assignment options for this board. Motorized Tail (MT) and Servo Tail (ST).
Motorized Tail option
Download the file below and Load config file to configure the servos and motors for the Motorised tail option.
Servo Tail option
Download the file below and Load config file to configure the servos and motors for the Servo tail option.
The FOXE-FOXEERF722V2(MT) and FOXE-FOXEERF722V2(ST) custom defaults are located in the custom defaults repository. Select the FOXE-FOXEERF722V2(MT) or FOXE-FOXEERF722V2(ST) board from the dropdown before flashing rotorflight. After loading "load custom defaults" to configure your hardware (e.g. Servo pins, motor pins, timers, DMA etc).