POWER SUPPLY - giantmolecules/SANDIN-IMAGE-PROCESSOR GitHub Wiki

The power supplies are purchased modules and should come with complete documentation; if not request from LAMDA.

In the IP, power supply regulation and high-frequency transient response are critical. Substitution of toher power supply modules is NOT recommended.

In each box all corresponding terminals of the 10 pin Jones connector are connected together.

The output of the power supplies are connected to the appropriate pin of one of the connectors.

In both power supplies (Box one and Box two), the binding post terminals are connected to the appropriate 10 pin Jones.

A cable with two male Jones plugs and corresponding pins connected together is used to communicate power between the boxes.

One side of each box should be covered with perferated metal or screen to allow for ventilation. This side should never be blocked to prevent ventilation. DO NOT let transistors touch screen.

The 110 v. AC which powers the power supplies is the only potentially lethal voltage in the IP. BE CAREFUL AND WATCH YOUR FINGERS.

--Box one contains +12, -12 power supplies.

--Box two contains +5, -5 power supplies.