SW_InstallPiStepbyStep - fablab-wue/piTelex GitHub Wiki
Step by step installation of the Raspberry Pi OS
-
Download RASPBIAN image and flash to MicroSD card (min. 8GB)
-
Boot the RPi (can take more than a minute at first time)
-
For the next steps you need access to the command line on the RPi. This can be done in different ways:
-
Use HDMI-monitor and USB-keyboard
-
Use a USB to Ethernet adapter:
- Use tools like nmap to find the IP address of the RPi in your local network.
- Use SSH to connect to this IP
Note: On Windows system use program Putty
-
Use a USB to Serial adapter with 3.3V TTL level:
- Connect to RPi debug-serial pins TXD and RXD
- Use SSH to connect to this tty
Note: On Windows system use program Putty
-
Change boot files on MicroSD card for headless NDIS (USB/Ethernet) connection:
- See: http://www.circuitbasics.com/raspberry-pi-zero-ethernet-gadget/ or https://www.factoryforward.com/pi-zero-w-headless-setup-windows10-rndis-driver-issue-resolved/
- Use SSH to connect to
raspberrypi.local
Note: On Windows system use program Putty Note: NDIS setup a network with address 169.254../16. It can take several minutes til the DNS entry is available
-
-
Login with user
pi
and passwordraspberry
-
Use
sudo raspi-config
to configure RPi system:- Set new password in menu
Change User Password
- Change device name in menu
Network Options
->Hostnames
(e.g. 'piTelex') - Set WIFI access to your local network. Set SSID and key in menu
Network Options
->WIFI
- Set Localization in menu
Localization Options
->Change Locale
- Set Timezone in menu
Localization Options
->Timezone
- Set new password in menu